Smart Appliances Guide

7-4
n
Connected Smart Appliances - Gen III
CLEAN-CONNECT DISHWASHER
Clean-connect Dishwasher
Component Tests
SERVICE DIAGNOSTIC CYCLE NOTES
1. To invoke the Service Diagnoscs cycle, perform the
following while in Standby:
n Press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with
no more than 1 second between key presses.
n The Service Diagnoscs cycle will start when the door
is closed.
n To rapid advance 1 interval at a me, press START/
RESUME. Rapid advance may skip sensor checks as
some checks require 2 complete intervals.
NOTE: The Service Diagnosc cycle will pause when the door
is opened and resume automacally upon door closure. No
Start/Resume key press is required to resume.
n Invoking Service Diagnoscs cycle clears all status and
last
n run informaon from memory and restores defaults. It
also
n forces the next cycle to be a Sensor Calibraon cycle.
Calibraon cycle may add addional rinses prior to the
nal rinse to ensure clear water and then calibrates the
OWI during the ll at the beginning of the nal rinse.
n Drain and wash motors will pulsate on and o.
n Last Ran cycles and opons returned to default.
n Last Ran Delay returns to the default delay seng.
n Operang state returns to Standby upon compleng
n or terminang the Service Diagnoscs cycle.
2. Press Hi Temp or Cycles key in this interval to clear customer
error history.
3. Thermistor (temperature sensor) checks:
n Turn Clean LED on if thermistor is in its normal
temperature range of 32°F–167°F (0°C–75°C).
n Turn Sanized LED on if Fill temperature is above 156°F
(69°C).
4. OWI (Opcal Soil Sensor) Checks:
n Check OWI sensor for the presence of water during
5 sec pause in interval 16 and turn on Clean LED in
interval 14 if water detected.
n Check OWI sensor for presence of bulk soil during
interval 12 and turn on Clean LED in interval 11 if bulk
soil is detected.
5. Diverter will be on connuously in intervals 14 and 13. In
all other intervals, diverter will be on only unl it reaches the
intended posion for that interval.
Clean-connect Dishwasher Diagnostics & Wiring Diagram
Figure 5 - Clean-connect Dishwasher Wiring Diagram
FOR SERVICE TECHNICIAN’S USE ONLY
W10887393A Assy: W10837601A
13y 5y data GND
1 2 3 4
WIN/ WIDE Connector P1A
RAST 2.5, 4 pin header OR JST 4 pin Header - Primary for External Uis
UI Connector Details
YL
YL
YL
YL
YL
YL
3
Diverter
Motor
1
BU
BU
P7-4
P7-6
3
1
Diverter
Position
Switch Contact
(ClosedDuring
Transitions)
P11-3 RD
P11-4 RD
Wi-Fi Module
J4
J2
ANTENNA
6
13V 5V data GND
Wiring Diagram
Schematic shown with door switch and all other normally open contacts open. *Denotes energy efficient components. Do not substitute.
© 2016. All rights reserved. 5/16
J2
ANTENNA
NOTE: Although the WiFi module will send an error to the ACU
during a fault, there is no “check” in diagnoscs mode that will
display it’s status.