Installation Guide

9
3-Wire Cable from Power Supply to 3-Wire Cable
from Cooktop
IMPORTANT: Use the 3-wire cable from power supply where
local codes permit connecting the frame-ground conductor to
the neutral (white) junction box wire:
1. Disconnect power.
2. Remove junction box cover if present.
3. Connect the flexible, cable conduit from the cooktop to
the junction box using UL Listed or CSA Approved conduit
connector.
4. Tighten screws on conduit connector, if present.
5. Connect the two black wires together using the UL Listed
wire connectors.
6. Connect the two red wires together using the UL Listed
wire connectors.
7. Connect the green or bare and white cooktop cable wires
to the white (neutral) wire in the junction box using the
UL Listed wire connectors.
8. Install junction box cover.
9. Reconnect power.
Complete Installation
1. Check that all parts are now installed. If there is an extra
part, go back through the steps to see which step was
skipped.
2. Check that you have all your tools.
3. Dispose of/recycle all packaging materials.
4. Use a mild solution of liquid household cleaner and warm
water to clean cooktop before use. Dry thoroughly with a soft
cloth. For more information, see the “Cooktop Care” section
of the Use and Care Guide.
5. Read the “Cooktop Use” section in the cooktop Use and
Care Guide.
6. Reconnect power.
7. Test the operation of the cooktop: verify that it heats and
the control light illuminates in the Hi, Med, and Lo positions.
Press OFF when done.
NOTE: If the cooktop does not work after turning on the power,
check that a circuit breaker has not tripped or a household fuse
has not blown. See the “Troubleshooting” section in the Use and
Care Guide for further information.
If You Need Assistance or Service:
Please reference the “Warranty” section of the Use and Care
Guide.
B
C
D
A
E
F
H
G
I
A. 3-wire cable from power supply
B. Red wires
C. Green wires
D. 3-wire cable from cooktop
E. Junction box
F. Black wire from power supply
G. UL Listed wire connector
H. Black wires
I. UL Listed or CSA Approved
conduit connector