Use and Care Guide

11
NOTE: It is possible to prepare two cups of espresso coffee at
the same time.
1. Press
2
during preparation of one espresso.
2. While the machine is making coffee, delivery can be
interrupted at any time by pressing
STOP
.
3. As soon as delivery has ended, to increase the quantity of
coffee in the cup, press
EXTRA
. Once the desired quantity is
reached, press
STOP
.
4. Once the coffee has been made, the appliance is ready to
make the next beverage.
NOTE: Various messages may be displayed while using the
appliance (FILL TANK, EMPTY GROUNDS CONTAINER, etc.).
Their meanings are explained in section "Displayed messages."
■ For hotter coffee, see "Tips for Hotter Coffee" section.
■ If the coffee comes out in drops, too weak and not creamy
enough or too cold, see the "Adjusting the Coffee Mill" and
"Troubleshooting" sections.
■ If "Energy Saving" mode is active, the rst coffee may take a
few seconds before it is delivered.
To Clean:
After every 14 cups of coffee made, the drip tray needs to be
cleaned and the coffee grounds container emptied.
1. Open the service door on the front by pulling the coffee spout.
2. Remove the drip tray and clean it.
NOTE: When cleaning the coffee system, always fully remove
the drip tray.
3. Empty the coffee grounds container and replace it.
NOTE: Every time the drip tray is removed, the coffee grounds
container must be emptied. Failure to do so may clog the
coffee system.
4. Replace the drip tray and close the service door.
Selecting the Coffee Size
From the home page, select the required size of coffee in the cup
by pressing SIZE.
SMALL SIZE
MEDIUM SIZE
LARGE SIZE
EXTRA LARGE SIZE
CUSTOM SIZE (if programmed) /
STANDARD SIZE
After delivering the beverage, the size setting is reset to the
MY
value.
Adjusting the Coffee Mill
The coffee mill is factory-set and should not require adjustment.
However, if after making the rst few coffees you nd that the
coffee is either too weak and not creamy enough, or delivery is
too slow (a drop at a time), this can be corrected by adjusting the
grinding adjustment dial.
NOTE: The grinding adjustment dial must only be turned when
the coffee mill is in operation during the initial phase of coffee
preparation.
1. If the coffee comes out too slowly or does not come out at
all, a message will be shown GROUND TOO FINE. ADJUST
GRIND LEVEL, turn the coffee mill dial one or two clicks
clockwise.
2. For fuller bodied creamier coffee, turn one click counter-
clockwise towards one. (Do not turn more than one click at a
time. Otherwise the coffee could come out one drop at a
time.)
The effect of these adjustments will only be evident after at least
two cups of coffee have been delivered. If this adjustment does
not obtain the desired result, repeat the correction by turning the
dial another click.
PUSH
PUSH
A
B
A. Coffee grounds container
B. Drip tray
MY
MY
MY
MY
MY
A
A. Grinding coarseness adjustment knob
A
B
A. Counterclockwise for ner grind
B. Clockwise for coarser grind