Use and Care Guide
16
5. Soak the infuser in fresh water for about ve minutes, then
rinse.
IMPORTANT: Do not use detergent to clean the infuser to
avoid removing the lubricant applied to the inside of the
piston.
6. After cleaning, replace the infuser by sliding it onto the
internal support and pin at the bottom, then push the PUSH
symbol fully until it clicks into place.
NOTE: If you are having difculty replacing the infuser,
compress the moving parts from both the top and bottom as
shown in the following illustration before reinserting it.
7. Once inserted, make sure the two colored release buttons
have snapped out.
8. Replace the drip tray and grounds coffee container. Close the
service door.
Cleaning the Milk Container
Each time a milk function is used, TURN MILK FROTH
ADJUSTMENT KNOB TO CLEAN TO START CLEANING appears
on the display and the milk frother lid must be cleaned.
1. Leave the milk container in the coffee maker. You do not need
to empty it.
2. Place a cup or other recipient under the frothed milk spout.
3. Turn the foam adjustment dial to CLEAN. CLEANING MILK
CONTAINER PLACE A CUP UNDER THE MILK OUTLET
appears on the display together with a bar which gradually
lls as cleaning proceeds. Cleaning will stop automatically.
4. Turn the dial back to a froth selection. Remove the milk
container and always clean the steam connection nozzle with
a sponge.
NOTES:
■ If a number of milk based drinks needs to be made, only
clean the milk container after preparing the last beverage. To
proceed with making the next beverages when the CLEAN
message is displayed, press
ESC
.
■ If the milk container does not get cleaned, the (clean milk
container icon) appears on the display as a reminder that the
milk container needs cleaning.
■ In some cases, to carry out the cleaning the appliance requires
a short time to heat up.
PUSH
A
B
A. Support
B. Pin
PUSH
C
L
E
A
N
CLEAN
A
B
C
D
A. Foam adjustment dial
B. Coffee spouts
C. Milk spout
D. Cup