Use and Care Guide

18
Displayed Messages
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
ADD PRE-GROUND
COFFEE, PRE-GROUND
MAXIMUM ONE
MEASURING CUP
The "Pre-ground coffee" function has been
selected, but without placing any pre-ground
coffee in the funnel.
Place pre-ground coffee in the funnel and repeat
delivery.
The funnel for pre-ground coffee is clogged. Empty the funnel using the brush provided as
described in the "Cleaning the Pre-Ground Coffee
Funnel" section.
A "Tall" coffee with pre-ground coffee has been
requested.
Place pre-ground coffee in the funnel and press
OK
to continue and complete delivery.
EMPTY GROUND
CONTAINER
The grounds container is full. Empty the grounds container and drip tray, clean and
replace them.
IMPORTANT: When removing the drip tray, the
grounds container must always be emptied, even if it
contains a few grounds. If this is not done, when you
make the next coffees, the grounds container may ll
up more than expected and clog the machine.
DESCALING NEEDED,
PRESS OK TO START
(~45 MIN)
Indicates that descaling is needed.
Press
OK
to start descaling or press
ESC
to
descale later. The descaling procedure described in
the "Descaling" section needs to be performed.
FILL BEAN CONTAINER The coffee beans have run out. Fill the beans container.
FILL WATER TANK WITH
FRESH WATER
The water tank is empty or incorrectly
positioned.
Fill the tank with fresh water and or insert it correctly
pushing it as far as it will go until it clicks into place.
ESC
PUSH
ESC
OK