Use and Care Guide

19
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
GENERAL ALARM:
REFER TO USER
MANUAL
The inside of the coffee system is very dirty. Clean the inside of the appliance thoroughly, as
described in the "Cleaning" section. If the message
is still displayed after cleaning, contact an authorized
Customer Service Center.
SELECT A MILDER
TASTE OR REDUCE
PRE-GROUND COFFEE
QUANTITY
Too much coffee has been used.
Select a milder taste by pressing or reduce
the quantity of pre-ground coffee (maximum one
measure).
GROUND TOO FINE.
ADJUST GRIND
LEVEL 1 CLICK WHILE IN
OPERATION
The grinding is too ne and the coffee is
delivered too slowly or not at all.
Repeat coffee delivery and turn the grinding
adjustment dial one click clockwise towards number
seven while the coffee mill is in operation. If after
making at least two coffees delivery is still too slow,
repeat the correction procedure, turning the grinding
adjustment dial another click. If the problem persists,
make sure the water tank is fully inserted.
If the water lter is present, an air bubble
may have been released inside the circuit,
obstructing delivery.
Insert the hot water/steam spout in the appliance
and deliver a little fresh water until the ow becomes
regular.
INSERT BREWING
UNIT
After cleaning, the infuser has not been
replaced.
Insert the infuser as described in the "Cleaning the
Infuser" section.
INSERT MILK
CONTAINER
The milk container is not inserted correctly. Insert the milk container as far as it will go.
ESC
PUSH