Use and Care Guide

20
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
INSERT GROUND
CONTAINER AND DRIP
TRAY
After cleaning, the grounds container has not
been replaced.
Remove the drip tray and insert the grounds
container.
INSERT WATER OUTLET The hot water spout is not inserted or is inserted
incorrectly.
Insert the water spout as far as it will go.
WATER CIRCUIT EMPTY
PRESS OK TO START
FILLING PROCESS
The water circuit is empty.
Press
OK
and allow fresh water to drain out of the
spout; the ow will stop itself automatically. If the
problem persists, make sure the water tank is fully
inserted.
PRESS OK TO START
CLEANING PROCESS OR
TURN MILK FROTH
ADJUSTMENT KNOB
The milk container has been inserted with the
froth adjustment dial in the CLEAN position.
To proceed with the CLEAN function, press
OK
or turn the froth adjustment dial to one of the milk
positions.
PUSH
OK