Use and Care Guide

8
Water Hardness
NOTE: The water hardness level is factory set at level 4. The
coffee system can be programmed according to the hardness of
your fresh water so the coffee system can be descaled less.
1. Remove the "Total hardness test" indicator paper provided
from the packaging.
2. Immerse the paper completely in a glass of fresh water for
about a second.
3. Remove the paper and shake lightly. After a minute, 1, 2, 3, or
4 squares will form. Each square corresponds to one level.
4. Press to enter the menu. Press or until the display
shows WATER HARDNESS.
5. To change the level selected, press the symbol itself until the
required level is displayed (Level 1 = soft water, Level 4 = very
hard water). Press
ESC
to return to the home page.
Auto-Off
Auto-off can be set so the coffee system turns off after 15 or 30
minutes, as well as 1-3 hours of no use.
1. Press to enter the menu.
2. Press or until the display shows AUTO-OFF together
with the current selection (15 or 30 minutes, 1, 2 or 3 hours).
3. Press to select the required value; then press
ESC
to
return to the homepage.
Coffee Temperature
1. Press to enter the menu.
2. Press or until the display shows COFFEE
TEMPERATURE together with the current selection (LOW,
MEDIUM, HIGH, or MAX).
3. Press to select the required temperature.
4. Press
ESC
to return to the home page.
Descaling
IMPORTANT: Before using, read the instructions and labels on
the descaler packaging.
Descale the appliance when the display shows DESCALING
NEEDED PRESS OK TO START (~45 min) . To descale
immediately, press
OK
and follow the steps.
1. "REMOVE WATER FILTER" will show on the display (if
present). Remove the water lter (if present) and empty the
water tank. Press
NEXT
.
2. ADD DESCALER (UP TO LEVEL A) AND FRESH WATER (UP
TO LEVEL B): Pour the descaler into the tank up to level A
marked inside the water tank. This is equal to one 100 mL
packet. Add 1 L (1 qt) fresh water up to level B and replace
tank. Press
NEXT
.
3. EMPTY GROUND CONTAINER AND DRIP TRAY: Remove,
empty and replace drip tray and the grounds container.
4. PLACE 2.5 L (3 qt) CONTAINER UNDER OUTLET, PRESS OK
TO START DESCALING: Place an empty 2.5 L (3 qt) or larger
container under the hot water/steam spout and coffee spout.
5. Press
OK
to conrm that descaling solution has been
added. The display will show DESCALING PLEASE WAIT,
which means the program has been started.
6. Descaler will come out of the hot water/steam and coffee
spouts. A series of rinses and pauses is automatically carried
out to remove all scale residue from the inside the coffee
maker.
7. After approx. 25 minutes, descaling will stop; RINSE AND
FILL WATER TANK UP TO MAX LEVEL will display. Empty the
container used for descaler solution and place back under the
spouts. Remove water tank, empty, rinse and rell to the MAX
level and replace tank. Press
OK
.
A
A. Water tank
*Water lter not available on this model.