Installation Instructions

3. It is recommended that if a wood or porous custom drawer

front is installed, a high-quality spray polyurethane nish be

applied to the inner wood surface.

4. For the lens, drill a 5/16" (7.9 mm) diameter hole through

the appearance side of the custom drawer front. This hole

will allow the “ON” Indicator Light to be visible through the

custom drawer front. To secure the lens, use an adhesive

specied for plastic-to-wood application.

5. Install custom handle (not supplied) through custom drawer

front.

6. The custom drawer front is fastened to the stainless steel

drawer by driving 6 screws through clearance holes in the

drawer front into the wooden or other custom made panel.

A. Optional handle

B. Custom door panel

C. Warming drawer front

D. #8-18 x 3/4" (1.9 cm) screws (6)

E. Lens