Installation Instructions

INSTALLATION
24 | INSTALLATION
2
Remove the old drain tube and clamp
attached to the ice maker bin.
NOTE: Discard old drain tube and
clamp.
1
Unscrew the screws attaching rear
panel to ice maker. Remove the screws
and rear panel, place them aside. For
pump models, skip to step 12.
INSTALLING THE DRAIN PUMP
AND DRAIN HOSE
Screws
Clamp
Old drain
tube
3
Install the drain pump on the right side
of the ice maker base. Tip the drain
pump slightly to slide the mounting
tab into the mounting tab slot.
Mounting
tab slot
4
Align the two screw holes at the rear
of the pump. Use the two #8-32 x 3/8"
screws supplied to attach the pump to
the ice maker base.
#8-32 x 3/8" pump mounting screws
NOTE: Do not kink, smash or damage tubes or
wires during installation.