Dimension Guide

JENN-AIR
®
DETAILED PLANNING DIMENSIONS
2 of 2
8998AdZw917
IMPORTANT: Dimensional specifications are provided for planning purposes only.
Do not make any cutouts based on this information. Refer to the Installation Guide before
selecting cabinetry, verifying electrical/gas connections, making cutouts or beginning installation.
All Jenn-Air
®
appliances are appropriately UL, CUL or CSA approved.
4" MODULAR DOWNDRAFT VENT
JVD0303GS – 3
7
⁄8" x 21"
OPENING/CLEARANCE DIMENSIONS
D* G
E
A
B
B
I
K
J
H
C
e
F
Side
Cabinet
H
D*
G
E
A
B
B
I
K
J
H
C
e
F
Side
Cabinet
H
D*
G
E
A
B
B
I
K
J
H
C
e
F
Side
Cabinet
H
MODEL # JVD0303GS
in cm
A
Width of combustible area above
cooking surface (min.)
18
7
⁄8 47.9
B
Width from vent module to fixed wall or
other combustible material (min.)
6 15.2
C
Width to outer edge of outlet (max.) 6 15.2
D*
Height to bottom of uncovered wood or
metal cabinet above cooking surface (min.)
30 76.2
E
Height to bottom of uncovered wood or
metal cabinet (min.)
18 45.7
F
Height to top edge of outlet (min.) 10 25.4
G
Depth of upper cabinet 13 33.0
H
Depth from cutout to wall (min.) 2
5
⁄16 5.9
I
Width of cutout with one module 18
3
⁄16 46.2
J
Depth of cutout (recommended) 20
3
⁄8 51.8
K
Depth from cutout to front of countertop 2
5
⁄16 5.9
e
Recommended electrical access location
* Dimension can be reduced by 6" (15.2 cm) when bottom of wood or metal
cabinet is covered by not less than
1
⁄4" (0.6 cm) flame retardant millboard
covered with not less than No. 28 MSG sheet metal, 0.015" (0.4 mm)
stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
If installing a hood or microwave hood combination above the cooktop,
follow the hood or microwave hood combination instructions for
dimensional clearances above the cooking surface.
FRONT VIEW
ELECTRICAL REQUIREMENTS
A 120 Volt, 60 Hz, AC only 15-amp fused, grounded electrical circuit is
required. A dedicated circuit is required.
A grounded 3-prong outlet should be located in the back of the cabinet.
Do not use an extension cord.
LOCATION REQUIREMENTS
• To ensure cooktop base clearance, cabinet side walls need to be wider
than the cutout.
TOP VIEWSIDE VIEW