Installation Guide

3
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools Needed
■ Tape measure ■ Marker or pencil
■ Phillips screwdriver ■ Pliers
■ Flat-blade screwdriver ■ Jigsaw
■ Level ■ Caulking
■ Drill ■ Aluminum duct tape
Parts Supplied
Check that all parts are included.
■ Blower housing assembly with electronic box and intake
assembly
■ (4) Mounting brackets (front and rear mounting brackets) with
screws
■ Grease lter
■ (2) Blower hold down brackets to secure blower to cabinet
■ Round duct 2-piece telescoping (blower assembly)
■ Foam strip
■ (4) Sheet metal screws to secure transition to downdraft
intake and one transition
Parts Needed
For vented installations:
■ 6” (15.2 cm) round metal ducting
■ Jenn-Air
®
wall cap:
Jenn-Air
®
6” (15.2 cm) round wall cap with damper
■ (8) Round or pan head wood and sheet metal screws
See the “Assistance or Service” section in your Use and
Care manual to order.
For non-vented installations:
■ Recirculation Kit part number W10807915 (See the
“Assistance or Service” section in your Use and Care
manualto order.)
a. Recirculation duct housing
b. (4) Mounting screws
c. (2) Charcoal lters
d. Recirculation housing cover
e. (2) Mounting screws – cover
f. Duct extension
g. (4) Mounting screws – duct extension
For non-vented installations side recirculation only:
■ 1-6” (15.2 cm) round 90 degree elbow and 1-6” (15.2 cm)
round to 3Z\v” x 10” (8.3 cm x 25.4 cm) transition and
1- 3Z\v” x 10” (8.3 cm x 25.4 cm) elbow.
■ Plywood Pedestal to raise blower mounting. See instruction
detail for non-vented installation.
Check local codes. Check existing electrical supply. See the
“Electrical Requirements” section.
It is recommended that all electrical connections be made by
a licensed, qualied electrical installer.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
When installing the downdraft, use the minimum dimensions
given.
■ Use the countertop opening dimensions that are given
with these Installation Instructions. Given dimensions are
minimum clearances and provide 0" (0 cm) clearance.
■ The model/serial/rating label is located on the front face of
the electrical junction box cover.
■ Grounded electrical supply is required. See the “Electrical
Requirements” section.
■ If cabinet has drawers, drawers will need to be removed
and drawer fronts installed on front of cabinet.
NOTE: The exhaust system is for outside venting. For
non-vented (recirculating) installation, see “For non-vented
(recirculating) installations only” in the “Connect Vent System”
section. Recirculating Kit part number W10807915 is available
from your dealer or an authorized parts distributor.
IMPORTANT: An undercounter built-in oven cannot be installed
under this product.
A
A. Model/serial/rating label location
Electrical Connection Locations
A. 3 prong grounding type outlet with correct polarity
B. 12” (30.5 cm) from centerline of downdraft intake
C. 18” (45.7) minimum
C
A
B
Center of Intake