Installation Instruction

Install Cooktop, Downdraft Vent and

Blower Motor Assembly

Prepare Blower Motor Assembly

NOTE: Remove shipping support from Blower Motor.

Vented

1. Secure with 3-screws and aluminum metal duct tape.

Assemble duct mounting ring to blower assembly with

3-screws. Position telescoping duct between intake

transition and blower motor (large duct to blower). Secure

ducting with sheet metal screws and use aluminum metal

tape to seal all joints.

A. Blower motor shipping support must be removed.

B. Wood block shipping support must be removed.

C. Blower Motor Housing.

D. Remove screw securing Wood Block to remove block.

Replace screw in blower housing sides after removing

wood block.

10. Install the recirculation cover to the recirculation assembly in

the cabinet kick plate.

11. Optional: The opening in the cabinet oor can be covered to

trim out the cabinet interior.

NOTE: Factory blower outlet position is rear-vented.

2. Prepare the blower assembly for installation and assemble

the two hold down brackets supplied on the blower.

3. Locate the downdraft vent in the countertop.

4. Assemble the supplied transition for connection to the

blower assembly using the four sheet metal screws supplied.

5. Assemble the telescoping duct, supplied to the blower

assembly. Secure all joints and seal using aluminum metal

duct tape.

6. Use wood screws to secure the blower to the cabinet oor

using the two blower hold down brackets supplied. Secure

one at the front and one at the rear.

A. Intake transition

B. Telescoping round duct

C. Blower ring

D. Blower motor