Installation Instruction
15
Internal (Non-Ducted) Venting and Right Discharge
Left Discharge
Rear Discharge
Complete Installation
1. Connect cable assembly and ground wire from vent intake to
blower motor. See following sequence gures.
A
B
C
D
E
A. Cable assembly from vent intake
B. Remove 3 screw and put aside you
will use later
C. Tape to be removed later
D. Blower / Motor
E. Electrical box
A
A. Assemble cable
Alternate Blower Conguration
NOTE: After establishing the location of the products to be
installed, the blower can be congured to support the desired
ducting location.
A)
B)