Installation Guide

Install the freezer handle

IMPORTANT: See Figure 2 and the Freezer Door table for handle

mounting hole requirements as well as handle mounting hole

locations.

1. Measure from the side of the custom panel and mark your

first hole location as shown in Figure 2 and the Freezer Door

table.

Figure 2: Freezer door

NOTE: Measurements from the top edge of the door will

depend on specific application.

2. Drill a ³⁄₁₆" (4.76 mm) hole at that location, then measure from

that hole over to the second hole. Countersink both holes on

the inside of the panel, ¹⁄₄" (6.35 mm) deep and ⁵⁄₈" (1.58 cm)

diameter for screw head clearance.

3. Install two mounting studs to the custom panel using the

screws provided. Check that the head of the screw is flush

with the panel.

4. Install handle to handle mounting studs and tighten the

setscrews. Some adjustments of the handle mounting studs

may be required to allow the handle to fit over both mounting

studs.

NOTE: The freezer handle setscrews should face down.

Freezer Door

Dimension Bottom Mount

Freezer

French Door Bottom

Mount Freezer

Euro handle Pro handle Euro handle Pro handle

A5"5⁵⁄₈"8⁹⁄₁₆"5³⁄₈"

B24³⁄₄"23⁹⁄₁₆"23⁹⁄₁₆"30"

Handle

Mounting Studs

Freezer

Compartment

Handle

Custom Freezer

Compartment Panel

#10-24 x 1" Screws

Setscrews