Spec Sheet

3. Replace the safety hitch pin in the guard.

4. Check and/or replace the plug with the UL/CSA listed plug for the rated current and voltage.

Follow the cord plug manufacturers installation instructions and procedures or contact a qualiﬁ ed

electrician.

Ensure that all connections are properly tightened. Improper connections could

result, causing damage, injury, or death of the equipment operator.

This machine must be connected in accordance with the National Electric Code

(NEC) Article 422-4 - Ed-31, Except as provided for in NEC 90-4.

This machine must be properly grounded to avoid fatal electrical shock in the event

of an electrical malfunction. A ground connector screw should be fastened into the

chassis to facilitate supplemental grounding as permitted by NEC 250-91.

Observe all local and national codes for the installation of this type of equipment.

If t here a re any quest ions or problems w ith the ele c t rical system being

use d ple a se, do not he sit ate in c a lling a local qualiﬁ ed ele c t ric ia n.

NOISE CONSIDERATIONS

Consult local ofﬁ cials for information regarding acceptable noise levels in your area. Hearing

protection may be required if in close proximity to the compressor. To reduce excessive noise, use

vibration mounts or silencers, relocate the unit away from the work area or construct total enclosures

or bafﬂ e walls.

LOCATION CONSIDERATIONS

Stationary Type Compressors

Stationary compressors are permanent type installations and typically are secured in place. There

are numerous ways to achieve this type of installation, the most common of which is bolting them to

directly to the ﬂ oor or other part of the building. Often times, vibration isolators are used to reduce

noise and vibration and increase stability.

Portable Type Compressors

Portable Compressors are much more universal and can be used in almost any location as long as

reasonable care is taken. Please refer to the Danger, Warning and Cautions as to location limitations

and safe operation.

Compressors run out of level by over 10 degrees may be

permanently damaged.

Consult all local codes and standards for information regarding installation and location of

compressors as they may differ from one locale to another.

NOTICE