Spec Sheet

6
Do not replace a fuse or circuit breaker with one of a higher rating without being certain the wire size
is adequate to handle the increased electrical load.
Keep all electrical connections dry and off of the ground.
Observe all local and national codes for the installation and use of this type of equipment.
Please use the following criteria for wire selection.
• 0 to 25 Feet from Main Power Source - At least the same size wire.
• 25 to 50 Feet from Main Power Source - At least one wire size larger.
• 50 to 100 Feet from Main Power Source - At least two wire sizes larger.
• 100 to 150 Feet from Main Power Source - At least three wire sizes larger.
If the wire size being used is too small, the voltage drop will be high, and this will cause the motor to
draw excessive current and overheat or fail.
If there are any questions or problems with the electrical system being used please, do not
hesitate in calling a local qualifi ed electrician.
2. Wear proper protective clothing and equipment.
Wear full eye protection (preferably a face shield) while operating this product. The
pressurized spray from this unit can cause severe injury to the eyes. It also may
contain irritants, particles or caustic chemicals.
3. Do not operate with protective covers or guards removed.
Operating this machine with the protective guards or covers removed could
expose high speed moving components which could allow the operator or
bystander to become entangled. Entanglement in this equipment may result in
serious injury, amputation, or death.
This unit may start and stop automatically when switch is in Auto mode.
4. Do not operate with any electrical panels or covers opened.
Operating this unit with any of the electrical panels or covers opened may expose
high powered electrical connections and/or components which may come in contact
with the operator. Contact with high powered electrical equipment by a person could
result in serious injury or death.
5. Do not operate this unit with any of the safety controls bypassed.
This unit was designed with safety in mind. Never allow anyone to bypass, modify, or alter any of the
safety devices on this unit. If any of the safety devices appear to be dysfunctional, do not operate the
unit and immediately contact a qualifi ed technician.
Periodically have all the safety devices checked for proper operation.