Spec Sheet
8
10. Never modify or alter this unit.
For your own safety as well as others, never allow this unit to be altered or modifi ed. Modifying or
altering equipment to operate in a fashion other than its original design may cause serious injury or
death.
Never exceed the factory pressure or temperature rating of the system. Be sure that all accessory
equipment and system components meets or exceeds the pressures and temperatures developed by
the unit.
11. Do not operate unit with damaged or worn hoses, fi ttings, clamps, or spuds.
Always check the connection hose, control hoses, fi ttings, clamps, and spuds
prior to operation. Replace all damaged or worn items with one which meets or
exceeds the specifi cations of the original equipment. The use of an improper hose,
fi tting, clamp, or spud may cause the hose, fi tting, clamp, or spud to rupture which
could result in serious injury or death or damage to the machine.
12. Do not repair damaged hoses or fi ttings.
Replace all damaged hoses and/or fi ttings with ones which meet or exceed the
specifi cations of the original equipment.
Do not use the hose if cuts, leaks, abrasions, bulges, or coupling damage is
evident.
Never remove any hose or fi tting while the unit is on. The risk of fl uid injection is
present.
13. Do not touch exposed metal such as the compressor pump, motor, tank,
connection hoses, or any fl uids.
This unit operates at extremely high temperatures. These temperatures may reach
in excess of 240° F. Touching any exposed metal or other surfaces may cause
severe burns.
Compressor will remain hot for a long period of time. Allow the compressor to cool
to room temperature before attempting any service or repairs.
14. Provide at least three (3) feet of clearance to adjacent construction.
This unit requires adequate ventilation and must be placed in a location which
provides at least three feet of clearance to all adjacent construction. This unit
operates at high temperatures and failure to allow adequate ventilation or restrict the
air fl ow may cause the machine to overheat or cause materials in close proximity to
reach their fl ash temperatures and ignite.