Installation Guide

1 628056_A
INSTALLATION INSTRUCTIONS
FOR RECESSED MOUNTED CABINET
(SURFACE MOUNT APPLICATIONS
REQUIRE A SURFACE MOUNT KIT)
PREPARATION
1. Carefully remove packaging materials. Hardware, shelves, and
door are located within the various packing materials. Place
hardware packages, shelves, and door aside until needed.
NOTE: For ease of installation, the assistance of an additional
person is recommended.
INSTALLATION
1. Determine the desired location for the cabinet on the wall.
Mark wall to show wall opening width and height (see chart
above). Generally, the recommended height of bath
cabinets is 64 from the finished floor to the center of the
cabinet. (Fig. 1) However, height may be adjusted to
individual preference.
2. The cabinet may be mounted with door opening to the right
or left side. Rotate the cabinet, top to bottom, to reverse
the door opening direction.
NOTE:
The rough wall opening must be free of obstructions. If
wall studs, plumbing, or electrical lines interfere with
the rough wall opening they must be removed /
relocated. This must be done in accordance with local
and national codes and it is recommended that the
services of a plumber or electrician be obtained.
3. Cut wall opening, being careful not to damage the surrounding
wall surface or any existing wiring or pipes that may be behind
the wall section being removed. Insert framing to support all wall
edges.
4. Insert mounting screws into the plastic bases (Fig. 2).
5. Level and plumb cabinet in center of wall opening. Use shims as
necessary. Use 4 mounting screws to attach cabinet to wall
studs (Fig. 3). Tighten screws until they are flush with the
housing. DO NOT OVER TIGHTEN. Over tightening may bend
housing sides and prevent proper shelf installation.
NOTE:
Do not use nails to attach the cabinet.
6. Snap the screw covers over the screw bases (Fig. 4).
D
W
H
Approx.
64” to the
floor
Fig. 1
Fig. 2
Insert
screw
through
clear
plastic
base
Fig. 3
Mounting
screws
Mounting
screw into
mounting
hole
Cover
Base
Screw
Fig. 4
Snap on cover
Model* Wall Opening
W H D
52WH244DP
S568N244SSWHP
62BK244CBK
62BK244CMP
52WH244DPF
S568N244SSBZP
62BK244CCN
S468244SS
72SS244D
S568N244SSSNP
62BK244CCY
14¼ 24 4
52WH344DP
S568N344SSBZP
S468344SS
52WH344DPF
S568N344SSSNP
72SS344D
S568N344SSWHP 14¼ 34 4
52WH254DP 52WH254DPF
19¼ 24 4
52WH304DP 52WH304DPF
23¼ 29 4
* Visit www.rangairemfg.com/products using the model number to see additional dimensions and features in the Product Specifications or Jensen Medicine Cabinet catalog.

Summary of content (8 pages)