User's Manual

POWER SOURCE (AC ADAPTOR ONLY)

The JTA-315 is powered by an external AC-DC adaptor with an output of DC 12V 2A .

POWER CONNECTION

1. Connect the cord of the power adaptor to the DC IN JACK (#17) at the back of the unit.

2. Plug the power adaptor into a household wall socket

SET UP THE SPEAKERS

Connect the speaker cables from each speaker to the back of the unit

Note: The external speaker connector are color coded, the red connector is plugged into a red jack on the unit (white

connector into the white jacks).

PHONO OPERATION

Please Note - Before Use

- Remove the stylus protector.

- Be sure that the TONE ARM (#7) is unlocked and free to

move from the TONE ARM REST prior to operating. Lock the

TONE ARM (#7) in place with the TONE ARM LATCH (#8)

when not in use.

1. Rotate the FUNCTION SELECTOR (#13) to the TAPE/PHONO mode.

2. Rotate the POWER / VOLUME CONTROL (#12) clockwise to turn on

the unit. The POWER/FUNCTION INDICATOR (#10) will turn on red.

3. Raise the turntable dust cover.

4. Place a record on the TURNTABLE PLATTER (#1), use the 45 RPM

ADAPTER (#3) if required.

5. Set the 33/45/78 RPM SELECTOR (#6) to the proper position

depending on the record to be played.

6. Lift the TONE ARM (#7) from the tone arm rest by using the TONE ARM LIFT LEVER (#4) and slowly move it

over the record. The TURNTABLE PLATTER (#1) will start to rotate.

7. Place the TONE ARM (#7) to the desired position of the record.

8. Adjust the volume to the desired level.

9. At the end of record, the platter will automatically stop spinning. Lift the

TONE ARM (#7) from the record and return it to the tone arm rest.

10. To stop playing manually, lift the TONE ARM (#7) from the record and return

it to the tone arm rest.

NOTES:

• The PITCH CONTROL KNOB (#16) allows you to fine tune the playing speed of the record once the correct

speed (33/45/78 RPM) is chosen. Turn the Pitch Control Knob to slightly increase or decrease the speed of the

turntable if necessary.

• Certain types of records may have an auto-stop area outside the preset limit, so the turntable may stop before

the last track finishes. If this occurs, set the AUTO STOP ON/OFF SELECTOR (#5) to the “OFF” position. This

allows the record to play to the end, but please note that it will not stop automatically. You must manually raise

the TONE ARM (#7) and place it back in the tone arm rest and then turn off the power to stop the turntable from

spinning.

• To play your record on external Bluetooth speakers (not included), see the Bluetooth OUT Operation section.