Use and Care Manual

E-11
RADIO OPERATION
1. Tap the POWER/STANDBY Button on main unit or remote control to turn on the unit.
2. Tap the MODE Button on main unit or remote control to select FM/AM mode, the FM/AM
radio frequency appear in display.
3.
To
manually
tune
to
a
specific
radio
station,
tap
the
TUNE
or
Button
on
either
main
unit
or
remote
control
repeatedly.
Use
the
manual
tuning
method
to
tune
in
weaker
stations
that
are
bypassed
during
Automatic
Tuning.
4. To automatically tune to the next available radio station, press and hold the or
Button on main unit or remote control for 1-2 seconds until frequency readout on the display
begins to scan and then release the button. The tuner will stop scanning when it receives the
next broadcasting station of adequate signal strength.
5. Press the volume control on main unit or remote control to adjust the volume control to the
desired volume level.
FM / FM Stereo reception
When listening to the FM radio, press the ST./MONO Button on remote control to switch
between stereo mode and mono mode. The FM stereo icon “ST” will appear on the display if
unit is in stereo mode. It is preferable to receive the program in mono when you are receiving a
weak station.
HINTS FOR BEST RECEPTION:
AM
-
The
AM
antenna
is
located
inside
the
cabinet
of
the
unit.
If
AM
reception
is
weak,
change
the
position
of
unit
until
the
internal
antenna
picks
up
the
strongest
signal.
FM
-
For
best
FM
reception,
the
FM
lead
wire
antenna
located
on
the
back
of
the
unit
should be fully unwrapped and extended.
NOTE: Automatic tuning depends on the signal strength of the broadcasting station, so weak
stations may be skipped. You can manually tune to find the weak stations if a station gets
skipped. With strong signals, the tuner may stop before it reaches the actual broadcast
frequency, so you may need to manually tune for the best reception.
PRESET RADIO STATIONS
1. Press the Button on main unit or remote control to turn on the unit.
2. Tap the MODE Button on main unit or remote control to select FM radio mode.
3. Press and hold the
PLAY/PAUSE
button on main unit or remote control until frequency
readout on the display begins to scan and then release the button for auto search and
program preset channels. “PROG” appears in display and flashing. Auto searching and
program will stop at P01 after scan finished, “PROG” shows in display steadily.
Note: If the channels stored during the auto search & programmed preset are not ones you
want saved, use the method below for the manually saving radio presets.
4. Tune to the desired radio station either by “manually” or “automatically” tuning method.
5. Tap the MEM. Button on main unit or remote control, the next available preset memory
number and a flashing “PROG” icon will show in the LCD display. (Note:”P01” will show in the
display if you are programming preset for first time)
6. Tap the PRESET+/- Button on main unit or remote control to select the preset number you
want to assign the station to.
7. Tap the MEM. Button to confirm the setting.
8. Repeat above steps 4 - 8 to preset up to 30 FM and 20 AM stations.
RECALLING PRESET MEMORY CHANNELS
In radio mode, recall the pre-set channels by pressing the PRESET+/- Button on main unit or
remote control repeatedly.