Use and Care Manual

E-15
PRESET EQ (REMOTE CONTROL ONLY)
This
unit
provides
4
different
EQ
modes
to
enhance
your
listening
experience.
You
can
select
the
desired
effect
by
pressing
the
EQ
Button
on
remote
control
repeatedly
at
following
sequence:
ROCK  POPS  JAZZ  CLASSIC  OFF
MUTE BUTTON (REMOTE CONTROL ONLY)
 Press the MUTE Button on remote control to mute the sound output from the speaker
temporarily. The “MUTE” icon will appear in display.
 Press the MUTE Button again or VOLUME CONTROL on remote control to resume to normal
speaker playback.
SLEEP OPERATIONS (REMOTE CONTROL ONLY)
The sleep timer allows you to turn the unit off after a designated time is reached.
1. To activate the sleep timer, turn the unit on and tap the
MODE
button
to select FM radio, CD,
Bluetooth or listening to music via AUX IN.
2. Tap the SLEEP button on remote control, the sleep time icon“SLEEP” appears on the display.
3. Repeatedly tap the
SLEEP
button
to select a sleep time. The unit will turn off after 10, 20, 30,
40, 50, 60, 70, 80 or 90 minutes. Wait for 3 seconds after your selection for the unit to confirm
the selection, the unit will play for the selected length of time then automatically turn off.
4. To cancel the sleep timer, tap the
SLEEP
button
repeatedly until timer shows “OFF”, the sleep
time icon “SLEEP” disappears on the display
5. To turn the unit off before the selected length of time, press the button at any time.
Notes:
1.) To check the remaining sleep time, tap the SLEEP button once.
2.) If you are falling asleep to music from an external device connected to the AUX input, the
sleep timer will shut off the power to this system but it will not turn off the external device.
USING
HEADPHONES
(NOT
INCLUDED)
Inserting the plug of your headphones into the Stereo Headphone Jack will enable you to listen to the CD or
Radio music in private. When using headphones, the Built-in Speakers will be disconnected.
READ THIS IMPORTANT INFORMATION BEFORE USING YOUR HEADPHONES
1. Avoid extended play at very high volume as it may impair your hearing.
2. If you experience ringing in your ears, reduce the volume or shut off your unit.
3. Keep the volume at a reasonable level even if your headset is an open-air type designed to
allow you to hear outside sounds. Please note that excessively high volume may still block
outside sounds.
ADJUST DISPLAY BRIGHTNESS (REMOTE CONTROL ONLY)
1. In Power on mode, press the DIMMER Button on the remote control to adjust the display
brightness. The brightness of the front panel display will change in the order shown below.
BRIGHT  DIM  MEDIUM
2. In Standby mode, press the
DIMMER
Button
on the remote control to adjust the display
brightness. The brightness of the front panel display will change in the order shown below.
DIM  MEDIUM  BRIGHT