Use and Care Manual

E-4
This equipment has been tested and found to comply with the limits for a Class B Digital Device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Changes
or
modifications
not
expressly
approved
by
the
party
responsible
for
compliance
could
void
the
user
’
s
authority
to
operate
the
equipment.
PROTECT YOUR FURNITURE
This
product
is
equipped
with
non-skid
rubber
'feet'
to
prevent
the
product
from
moving
when
you
operate
the
controls.
These
'feet'
are
made
from
non-migrating
rubber
material
specially
formulated
to
avoid
leaving
any
marks
or
stains
on
your
furniture.
However
certain
types
of
oil
based
furniture
polishes,
wood
preservatives,
or
cleaning
sprays
may
cause
the
rubber
'feet'
to
soften,
and
leave
marks
or
a
rubber
residue
on
the
furniture.
To
prevent
any
damage
to
your
furniture
we
strongly
recommend
that
you
purchase
small
self-adhesive
felt
pads,
available
at
hardware
stores
and
home
improvement
centers
everywhere,
and
apply
these
pads
to
the
bottom
of
the
rubber
'feet'
before
you
place
the
product
on
fine
wooden
furniture.