MODEL JCR-255 AM/FM DUAL ALARM AUTO TIME SET CLOCK RADIO INSTRUCTION MANUAL Please read and follow this instruction manual carefully before using the unit and retain it for future reference
DEAR JENSEN ® CUSTOMER Selecting fine audio equipment such as the unit you've just purchased is only the start of your musical enjoyment. Now it's time to consider how you can maximize the fun and excitement your equipment offers. This manufacturer and the Electronic Industries Association's Consumer Electronics Group want you to get the most out of your equipment by playing it at a safe level.
WARNING TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. 1. 2. 3. 4. 5. 6. 7. Read these instructions Keep these instructions Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth.
13. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as powersupply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. 14. This appliance shall not be exposed to dripping or splashing water and that no object filled with liquids such as vases shall be placed on the apparatus. 15.
IMPORTANT NOTES Avoid installing the unit in locations described below: Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters. Dusty places. Places subject to constant vibration. Humid or moist places. COMPLIANCE WITH FCC REGULATIONS This device complies with Part 15 of the FCC Rules.
POWER SOURCE This unit is designed to operate on 120V/60Hz AC house current. Operating this unit from any other power source may cause damage to the unit, and such damage is not covered by your warranty. The radio is also pre-loaded with 2 x “AA” batteries for the battery back-up and for the Auto Time Set clock system.
2 4 1 3 5 6 7 14 10 9 13 8 12 11 15 1. POWER ON/OFF BUTTON 9. TUNNING CONTROL 2. VOLUME CONTROL 10. TIME ZONE SELECTOR 3. CLOCK SETTING UP BUTTON 11. DAYLIGHT SAVING TIME SWITCH 4. CLOCK SETTING DOWN BUTTON 12. DIMMER CONTROL 5. ALARM1 BUTTON 13. AUX IN JACK 6. ALARM2 BUTTON 14. AUX/RADIO SELECTOR 7. SNOOZE BUTTON 15. BATTERY COMPARMENT 8.
1 3 4 2 5 6 1. ALARM 1 INDICATOR 4. AM CLOCK INDICATOR 2. ALARM 2 INDICATOR 5. PM CLOCK INDICATIOR 3. MULTI FUNCTION DISPLAY 6.
AUTO TIME SET This unit features an Automatic Time Set system powered by 2 X “AA” batteries (3V DC) (Included), so you do not need to set the clock time when first plugged in. After the unit is plugged in, the LED display will show the current time automatically after you set the time zone and daylight saving time for desired area. SETTING THE TIME ZONE Change to your time zone area by sliding the TIME ZONE switch on the back of the unit to the appropriate time zone you live in.
SETTING THE CLOCK In case the back-up batteries are accidentally removed. You will need to set the clock manually. If the LED display is blinking 1. In standby mode, press the UP button to increase or press the DOWN button to decrease the minutes setting. 2. Press and hold the UP / DOWN button to fast forward/backward the clock setting. 3. Press the BAND/SET button or waiting 5 seconds to confirm the setting. If the LED display is steady 1.
6. When you have finished listening, press the ON/OFF button once to turn off the unit. TIPS FOR BEST RADIO RECEPTION AM - The AM antenna is built inside the radio. If AM reception is weak, change the position of the unit until the internal antenna picks up the strongest signal. FM - If FM reception is weak, fully extend the wire antenna and vary the position and location of the antenna until you find the strongest signal. ALARM OPERATION SETTING THE WAKE UP TIME This unit has Dual Alarm function.
5. 6. To stop the alarm immediately, press the ON/OFF button once. The radio will stop but the alarm remains set and will turn the unit on again at the same time on the following day. To turn off the alarm completely, press the ALARM button repeatedly until ALARM indicator turns off. WAKE TO BUZZER 1. To select wake to buzzer mode, press the ALARM button repeatedly until the display shows “bUZ”. 2. Release ALARM button and wait about 5 seconds to confirm the setting. 3.
BACKLIGHT BRIGHTNESS OPERATION You can change the LED brightness by switching the HI / LO dimmer switch located on the side of the cabinet. AUXILIARY INPUT This unit features an AUX line-in jack for connecting your iPod, MP3 player or other digital music players. 1. Connect the headphone jack of your external device to the AUX IN jack located on the back of the unit (cable not included). 2. Turn on the unit and set the FUNCTION Selector to the “AUX IN” position. 3.
SPECIFICATIONS Power Requirement: Battery Backup For Clock: Frequency Range: AC 120V~60HZ 6W 2 X”AA” (UM-3) AM 530-1710kHz, FM 88-108MHz SERVICE Please refer to the instructions on the enclosed warranty card for returning your unit for service. When returning the unit, please remove the battery to prevent damage to the unit in transit and/or from possible battery leakage. We are not responsible for battery returned with the product or for the cost of replacement.
