Owner's Manual

JWM92A
9
Reset
HDMI ARC
The reset button should be activated for the following reasons:
Use a ball point pen or similar object to press the RESET button (4). This may be
necessary should the unit display an error code.
Connect HDMI cable to JENSEN TV with ARC function and JWM92A radio head unit.
If the set up and operation is correct, the TV audio will come out from the speaker of
the head unit after switching to HDMI ARC mode.
Ÿ Initial installation of the unit when all wiring is completed
Ÿ Function buttons do not operate
Ÿ Error symbol on the display
Liquid Crystal Display (LCD)
Dimming control
Clock Setup
Sleep Mode Setup
Press the Clock button (27) to access clock set up mode. The hour clock digit
will flash, Rotate the VOL/ENTER knob clockwise or counter-clockwise to adjust
the hour. Press the ENTER knob to access the minute adjustment. Press the
ENTER knob again to save the clock. If the new time is not confirmed by
pressing the ENTER button, the unit will automatically exit the clock setting
menu after 10 seconds of inactivity and the new time will be set.
The sleep timer will automatically turn off the JWM92A in designated number of
minutes. To set the Sleep Time, press the SLEEP button (28) and the sleep time
will appear in the display with the number representing the minutes (SLEEP 15).
Press the SLEEP buttons (28) or rotate the VOL/ENTER knob clockwise or
counter-clockwise to change the sleep time from SLEEP OFF, 15, 30, 45 or 60
minutes.
NOTE: USB will not support Apple device playback. The USB input supplies
up to 1A of charging current.
NOTE: When subjected to cold temperatures for an extended period of
time, LCD panels will take longer to illuminate and the display visibility
may slightly decrease. Optimal LCD operation will return to normal when
the temperature increases to a normal range.
Ÿ 1. Press the DIM button (6) on the front panel to turn the dimmer On
(selected brightness level) and press again to turn the dimmer Off (maximum
brightness level).
Ÿ 2. Press & Hold the DIM button (6) to access DIMMER LEVEL menu.
Ÿ 3. Rotate the volume knob clockwise to increase or counter-clockwise to
decrease the brightness of button and LCD backlight from “BRIGHTNESS 0”
to “BRIGHTNESS 8”. “BRIGHTNESS 0” indicates the LCD backlight is
turned off.
Ÿ 4. Press the BACK button (2) to confirm your selection and exit menu.
The current activated functions and time are shown on the LCD panel (8).
Alarm Setup
The alarm will turn on the unit from standby at a specific set time. Last mode will play.
Press the ALARM button (29) to turn alarm function on or off.
Press and hold the ALARM button to access alarm setting, the hour clock digit will
flash, Rotate the VOL/ENTER knob clockwise or counter-clockwise to adjust the
hour. Press the ENTER knob to access the minute adjustment. Press the ENTER
knob again to save the alarm time and return to ALARM ON/OFF setting.
USB Interface Connector
You can connect a USB device directly to USB interface (11) on the front of the
JWM92A for playback of compatible files. Press the USB button (22) to switch to
USB mode from another source for active zone.