IMPORTANT SAFETY INSTRUCTIONS FOR AUDIO PRODUCTS-READ CAREFULLY ALL THE FOLLOWING IMPORTANT SAFEGUARDS When using electrical products, basic precautions should always be followed including: 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. Read Instructions - All the safety and operating instructions should be read before the product is operated. Retain Instructions - The safety and operating instructions should be retained for future reference.
18. Damage Requiring Service - Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: A. If the power-supply cord or plug is damaged. B. If liquid has spilled, or objects have fallen into the product. C. If the product has been exposed to rain or water. D. If the product does not operate normally by following the operating instructions.
CAUTION: z In order to shut off the power to this product completely, unplug the power cord from the wall outlet. be sure to unplug the unit if you do not intend to use it for an extended period of time such as a vacation. z z Do not remove the protective housing. Use of controls and adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
Before Use 1. 2. 3. 4. 5. 6. 7. Choose unit installation location carefully. Avoid placing it in direct sunlight or close to a source of heat. Also avoid locations subject to vibrations and excessive dust, cold or moisture. Keep away from sources that hum, such as transformers or motors. Do not open the cabinet as this might result in damage to the circuitry or electrical shock, if a foreign object should get into the set, contact your dealer. Be sure not to handle discs with dirty fingers.
Handling a record, tape or compact Disc Compact Disc Handing the Discs: This unit has been designed specifically for sound reproduction from compact discs bearing the mark . No other discs can be used. z Always place the compact disc in the disc tray with the label facing upward. (Compact discs can be played only on one side). z To remove a disc from its storage case, press down on the centre of the case and lift the disc out, holding it carefully by the edge.
How to Replace the Turntable Stylus Removing old stylus 1. Set a screwdriver at the tip of the stylus and push down to the direction "A". 2. Remove the stylus by pulling it down and forward. Installing a new stylus 1. Hold the tip of the stylus and insert the other edge by pressing in the direction "B". 2. Push up in the direction "C" until it locks at the tip. Basic Operation 1.Power on. Connect the power plug into the wall outlet. Turn the unit on by turning the volume knob clockwise.
Listening to a Record 1. Press the PHONO button. 2. Select player speed. 3. Put a record onto the turntable (use the 45 rpmadaptor provided when playing a single record). 4. Remove the tone arm-rest holder. 5. Lift the Que-lever and move the tone arm gently to the desired position over the record. 6. Lower the Que-lever slowly. 7. Return to the tone arm to the tone arm-rest after reaching the end of the record. Listening to TAPE 1. 2. 3.
Listening to a CD 1. Press the CD button. "--" blinks for a few seconds, when the CD exit and enter into CD door, or the unit do not play CD. 2. Open the tray by pressing the OPEN/CLOSE button. Then put the CD on the tray. 3. Press OPEN/CLOSE button to close the tray, then press PLAY/PAUSE button to start playing the CD. The CD will start playing from the first track. 4. Press the F.F button once to go the start of the next track. 5. Press the F.
Listening to the Radio 1. Press the AM or FM button to select the desired band. AM FM 2. Tune to the desired frequency. 3. FM Reception Any strong FM station will cause the FM Stereo Indicator (FM ST ) to illuminate. Weaker stations cannot be received in stereo 4. Antenna For optimal FM reception stretch the built-in FM antenna wire located at the lower back of the unit and move it around until the station you have tuned in is being received clearly.
Troubleshooting Guide If you experience difficulties in the use of this music system, please check the followings or call at CD PLAYER TUNER UNIT TAPE DECK THE WHOLE UNIT 1-800-777-5331 for Customer Service and Support. Problem Power does not come on when the power switch is pressed. No sound comes out of the speakers. Cause Solution Unit is unplugged. Connect the unit to the AC power supply. The volume is turned down (to MIN). The input selector does not match the playback source.
COMPLIANCE WITH FCC REGULATIONS This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
