Quick Start Manual

VM9026

What’s in the Box

VM9026 Head Unit

Trim Ring

Power Input Harness

Speaker Harness

Accessory Harness

Operation Manual

Installation Guide

Tools and Supplies

You will need these tools and supplies

to install your VM9026:

• Torx type, at-head and Philips

screwdrivers

• Wire cutters and strippers

• Tools to remove existing radio (screw

driver, socket wrench set or other

tools)

• Electrical tape

• Crimping tool

• Volt meter/test light

• Crimp connections

• 18 gauge wire for power connections

• 16 – 18 gauge speaker wire

WARNING! Never install this unit where operation and viewing could interfere with

safe driving conditions.

PAGE 1
VM9026 What’s in the Box VM9026 Head Unit Trim Ring Power Input Harness Speaker Harness Accessory Harness Operation Manual Installation Guide Tools and Supplies You will need these tools and supplies to install your VM9026: • Torx type, flat-head and Philips screwdrivers • Wire cutters and strippers • Tools to remove existing radio (screw driver, socket wrench set or other tools) • Electrical tape • Crimping tool • Volt meter/test light • Crimp connections • 18 gauge wire for power connections •
PAGE 2
Optional Equipment • Rear Camera Disconnecting the Battery • T o prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. NOTE: If the VM9026 is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution during installation to avoid causing a short circuit.
PAGE 3
Wiring Diagram CAUTION! IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, or have the installation handled by an experienced technician. Need Help? For technical assistance, call the Jensen customer support line at 1-800-323-4815.
PAGE 4
128-9196