Owner's Manual

VM9116

To exit the balance-fader:

• touch the X button on the top left corner of the screen or press and hold the

rotary encoder.

• touch the EQ button on the left side of the screen to display the equalizer

screen.

System Reset

To correct a system halt or other illegal operation,

use the tip of a pen to press the reset button

[RESET] Button

located on the front bottom-right corner of the unit.

After a system reset, the unit restores all factory default settings.

NOTE: If the unit is reset while a DVD is playing, the DVD resumes play once the

reset is complete.

Image/Display Settings

Video Output Modes

Table 4 shows the video output mode for each playing source.

Table 4: Video Output Modes

Playing Source Video Output Modes

AM/FM TUNER YCbCr Mode

DVD YCbCr Mode

AUX IN CVBS Mode

*CVBS – Composite Video Baseband Signal

Picture Adjustment

To adjust monitor display settings, perform the following steps:

1. Press the PIC button on the monitor to display the picture adjustment menu.

The “BRIGHT” bar is highlighted in yellow.

2. Turn the rotary encoder to adjust the brightness setting level.

3. Press the PIC button again. The “CONTRAST” bar is highlighted in yellow.

4. Turn the rotary encoder to adjust the contrast setting level.

5. Press the PIC button again to exit the picture adjustment menu.

Parking Brake Inhibit

When the pink “Parking” wire is connected to the vehicle Parking Brake circuit, the

front TFT monitor will display video when the Parking Brake is engaged. (When

the pink wire is grounded via the Parking Brake circuit, video will be displayed.)