Quick Start Manual

ManualsBrandsJensen ManualsAudioJensen VM9225BT

VM9225BT

Installation Guide

What’s in the Box

VM9225BT Head Unit

Left and Right Double DIN

Mounting Brackets

Double DIN Half Sleeve Install Bracket

Two Custom Cosmetic Trim Rings

Parking Brake Wire

Hardware Bag

Speaker Output Harness

Power Input Harness

Accessory Harness

Installation Guide

External Microphone

NAV104 Interface Harness

Tools and Supplies

You will need these tools and supplies to

install your VM9225BT:

• Torx type, at-head and Philips

screwdrivers

• Wire cutters and strippers

• Tools to remove existing radio (screw

driver, socket wrench set or other

tools)

• Electrical tape

• Crimping tool

• Volt meter/test light

• Crimp connections

• 18 gauge wire for power connections

• 16 – 18 gauge speaker wire

WARNING! Never install this unit where operation and viewing could interfere with

safe driving conditions.

Summary of content (4 pages)

PAGE 1
Installation Guide VM9225BT What’s in the Box VM9225BT Head Unit Left and Right Double DIN Mounting Brackets Double DIN Half Sleeve Install Bracket Two Custom Cosmetic Trim Rings Parking Brake Wire Hardware Bag Speaker Output Harness Power Input Harness Accessory Harness Installation Guide External Microphone NAV104 Interface Harness Tools and Supplies You will need these tools and supplies to install your VM9225BT: • Torx type, flat-head and Philips screwdrivers • Wire cutters and strippers • Tools to
PAGE 2
Optional Equipment • NAV104: Allows you to access navigation features. All installation and operating instructions are included with the navigation module. • Rear Camera Disconnecting the Battery • T o prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. NOTE: If the VM9225BT is to be installed in a car equipped with an on-board drive or navigation computer, do not disconnect the battery cable.
PAGE 3
Installation Using Half-Sleeve 1. Install half-sleeve in the dashboard. a. Install adapter if necessary (optional). b. Install half-sleeve into adapter or dashboard (use only the supplied screws). Do not force the sleeve into the opening or cause it to bend or bow. WARNING! Only connect the unit to a 12-volt power supply with proper grounding. c. Locate the series of bend-tabs along the top, bottom and sides of the mounting sleeve.
PAGE 4
Wiring Diagram CAUTION! IMPORTANT: Incorrect wiring connections can damage the unit. Follow the wiring instructions carefully, or have the installation handled by an experienced technician. Need Help? For technical assistance, call the Jensen customer support line at 1-800-323-4815.