Owner's Manual
Table Of Contents
- Installation / Quick Start Guide (Downloaded from Jensen)
- Installation Guide (Supplied with Product)
- Operation Manual
- Reset (Button #6)
- Bluetooth PIN (5309)
- Table of Contents
- Features
- Parts & Controls
- Remote Control
- Using the TFT Monitor
- External Devices
- Quick Start Guide
- Equalizer Control Menu
- System Settings
- Disc Operation
- Tuner Operation
- USB Operation
- iPod / iPhone Operation
- AV-In1 / AV-In2 Operation
- Bluetooth Operation
- Rear Camera Operation
- Steering Wheel Control Operation
- Pandora Operation
- SiriusXM Operation
- Care and Maintenance
- Specs
- Warranty
21
VX4012
Beep - Touch ON or OFF to turn the selection confirmation beep ON or OFF.
Calibration- The Touch Screen Calibration adjustment is used to set the
parameters of the touch screen to ensure that when the screen is touched, it
corresponds to the feature desired.
Note: Never use a pen or sharp object to calibrate the touch screen as this will
damage the panel.
1. Touch the Calibrate icon and the first screen will appear with instructions.
2. Follow the instructions on the screen touching and momentarily holding
finger or a stylus to the center of the target for 2 seconds. Repeat as the target
moves to each corner of the screen and finally to the center.
Calibration Screen
3. The second screen will appear:
Calibration Screen Confirmation
4. If the screen is touched, the new calibration parameters will be accepted. If
the screen is not touched within thirty seconds, the new parameters will be
disregarded.
Wallpaper - Touch wallpaper selection to select wallpaper. Touch again
to confirm and set the wallpaper.