Instruction Manual

7.2.2 Selecting Result’s Destination
The autolog menu enables the result’s destination to be
set. To select the internal printer press the key adjacent
to the printer icon. This option is only available if an
internal printer is connected. To send the results to an
external instrument such as a PC or a serial printer press
the key adjacent to the computer icon.
7.3 CONNECTING TO A PC
Connect the interface cable to the RS232 serial port on the rear of the instrument and connect to the
serial port on the rear of the PC. Turn the PC on and load the PC software by inserting the PC software
disc into the CD drive. If the PC software does not auto run open My Computer and double click on
the Jenway 73 series software icon. Follow the instructions to install the PC software to the required
location. Refer to the PC software manual for further instructions. Once the software is installed, turn
the mains power on to the instrument.
The PC software is pre-configured to run using the following settings:
9600 baud
8 data bits
No parity
1 stop bit
0005 010s
X
28