Manual

7
Programming to USB Drive
You can download and program data updates directly to a USB drive. You must be connected
to the Internet and logged into IDM before starting the programming process for your data
services.
Note: Honeywell recommends the USB be formatted in FAT32 file system to maximize
compatibility across Data Management Units (DMU) / Data LAN Management Units (DLMU).
1. Click on a service in the Services Area that is Available for Update. Drag to the media in
the Update Options Area and drop the service to start the programming process. In the
picture shown below, the USB drive is named AIRCRAFT01 and is using the FAT32 type
file system. The green shading indicates that the USB drive is a valid drop target.
2. The service will download first and then program. You will receive pop-up messages in
the upper right corner with status information.
3. Once the spinning arrows next to the drive name stop, be sure to use the eject function
(the up arrow icon) before removing the USB drive from the computer.
Programming to a USB Drive Offline
IDM has the functionality to download a service to your computer when you are online and
program the service to a USB drive at a later time. You must be connected to the Internet and
logged into IDM before starting the download process. You can program the service at a later
time, while offline.
Online
1. Click on a service in the Services Area that is Available to Update and drag to Local
Storage under DOWNLOAD ONLY in the Update Options Area.