Specification

10
Warning
A、make sure the water tank ,water filter and the water separator pipe is not
blocked, clean them
B、The water temp will effect the ice making capacity.The lower temp,the more
ice cube produce.
C、The cooler ambient temp, the more ice cube produce.
D、always use good quality water to make sure the pump work well.Bad quality
water will cause pump noise,but doesn’t effect the unit working.
E、The compressor restart 3mins later if you turn off the unit.
PROBLEM
POSSIBLE CAUSE
SOLUTION
< > is on
Lack of water
Turn off the unit and add water to
<FULL>level, then re-start the unit.
< >is on
Too much ice cube in the
basket
Remove the ice cube in the basket
The water reservoir has
water,but< > is on
The inlet solenoid valve
breakdown
Need the technical service person to
maintain
<E1> is on
Ambient temp sensor
breakdown
The unit can still work, change a new
sensor
<E2> is on
Water temp sensor
breakdown
The unit can still work, change a new
sensor
No water in the water
Separator pipe
The holes are blocked
Use slim wire to prick each hole, till
The water can flow out easily.
Water filter block
Clean the water filter
Ice cube thick and can’t
Drop down
Ice making cycle too long
Press <->to reduce the ice making
time.
Ice cube thin
Ambient temp too high
Move the unit to cool place
Water temp too high
The water temp should be no more
morethan25℃（77℉）.
Ice making short
Press<+>to increase the ice making
Time.
Unit work but no ice cube
Ambient temp is high or the
Water temp is high
Move the unit to somewhere ambient
Temp lower than30℃(86℉),fill cool
water.
Refrigerant system
leakage
Need the technical service person to
maintain
Refrigerant system block
Need the technical service person to
maintain
TROUBLESHOOTING