Specification

8
Operation panel and display area
1. Remove the cover of the water reservoir and pour potable water into water reservoir.
And be sure to keep water level below the max. level with FULL mark displayed in following
picture.
Warning: Do not pour the water into the internal water tank located underneath
the ice basket. This tank is not big enough and will effect the ice making
performance.
2. How to turn on the unit: Plug the unit, electric power symbol < >will start to flash, and the
present ambient temperature will display at top left corner of the displaying window, for
example, “80F” letter means the 80 Fahrenheit ambient. Again press the “ON/OFF” button to
start the unit, first the water will flow into the water tank to the standard water level, then the
compressor start to run to make ice-cube, at same time, power symbol< >will change to
display always and ice-cube symbol < >will be rotating state, the ambient temperature
display will disappear. After some minutes of ice-making duration, the flashing digit will
display in the the ambient temperature displaying area, for example, the flashing digit “10M”
means that it will take 10 minutes to complete this time ice-making process.
3. When ice maker harvest,symbol< > flash, the water will flow from top water reservoir to
bottom water tank through solenoid valve,the symbol < > will be on ,when the water in
the bottom water tank is full,the symbol < > will be off,then the next ice making cycle
start again.When there is no water in the water reservoir, the symbol < > will keep on.
Turn off the unit and fill water again, then restart the unit to make ice cube.Or fill water
directly and wait 20mins,the unit will restart .
Remark:The ice making cycle lasts about 13 to 25 minutes, depending on the ambient
temperature. And for the first time, according to the initial water temperature, ice-making last time
will be a little longer. In the extreme hot room temperature, ice-making time may be
Vary a lot, but it will not exceed35minutes.
If you think the ice cube is not thick enough, during ice making,press the<+>and<->to
set the ice making lead time. Press one time and the ice making cycle will in crease or
Reduce one min,6min most.This can only start from the new cycle.
USING YOUR ICE MAKER
DISPLAY
AREA
OPERATION
AREA
OPERATION
AREA
Cover for the water reservoir