Use and Care Manual

10
Using your Induction Hob
To start cooking
1. Touch the ON/OFF key(C)” ”for 3 seconds.
After power on,the buzzer beeps once,all displays
show “– “,indicating that the induction hob has
entered the state of standby mode.
2. Place a suitable pan on the cooking zone that
you wish to use.
• Make sure the bottom of the pan and the surface
Of the cooking zone are clean and dry.
3. According to the heating zone where the pan is placed,select a relevant
zone select key by pressing the relevant zone select key(A) “ ”.The
symbol“0”,selected will stay fully it.
4. Select the power level by pressing the key (E)” ” or the key(D)” ”
5. The power level will start at 5.Pressing the “+”will count up the power levels
from 5 to 9 in numerical order.Pressing the “-”key will take the power
straight from 9 to 0
• If you don’t choose a heat setting within 1 minute,the induction hob will
automatically switch off.You will need to start again at step 1.
• You can modify the heat setting at any time during cooking.
alternately with the heat setting
If the display flashes
This means that:
• You have not placed a pan on the correct cooking zone or,
• The pan you’re using is not suitable for induction cooking or,
• The pan is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 1 minutes if no suitable pan is
placed on it.