User's Manual

B. Introduction to 2.4GHz Wireless AV Link
This sender system is a wireless audio/video sender that uses advanced wireless
communication technology to deliver consistently sharp audio and video up to
100 meters away. By transmitting at a very high frequency (2.4 GHz), it avoids
the crowded 900 MHz band used by many cordless telephones and other
wireless audio/video transmitters. It
’
s superior quality is due to wide-band FM
rather than AM signal modulation.
It also integrates an UHF remote control extender to allow you to control the
audio or video source from another room using your existing remote controller.
Using sender system, you can enjoy greater convenience and security in many
ways:
General Application
•
Watch the movie you rent on any TV in house without moving your VCR,
laser disc player or running messy cables.
•
Watch cable or satellite programs on any TV in house.
•
Listen to stereo-quality music from your receiver on any powered speakers
inside or outside the house.
•
Uses multi-receivers for broadcasting to numerous TV sets in other rooms.
•
Show computer images on a remote TV. (Additional equipment required)
Safety & Security Application:
•
A
pplies as a wireless security system.
•
Monitor your sleeping baby, playing children, the elderly, or the disabled
on TV using your existing camcorder.
•
See who is outside the door on TV through your camera or miniature
CCD camera.
•
Monitors and records meeting from another room.
•
And many more uses!
3
■
The Using Attention
1. The outlet of the power supply must have the same voltage as the local area.
2. Be sure the transmitter and the receiver were connected to the equipment
Correctly (e.g. Connect the transmitter to the VCR, and the receiver to the
TV).
3. When switch is off from transmitter or receiver, it needs to wait for a few
seconds in order to restart again.
4. When two equipment or more is used at the same time, used different
channels. But a transmitter can be used with several receivers at the same
time.
5. When the equipment is operating, please do not use a microwave oven
near by.
6. The remote controller should face to the receiver IR remote control window,
and the transmitter IR extender should face to the source A/V equipment.
The IR remote has to be within the standard distance.
4