User's Manual

■ Important-Safety Precautions
A. Checking Contents of Box
This device of which operation is subject to the following two conditions
Checks to make sure that all of the items shown as below are included with
your 2.4 GHz Wireless Audio Sender System. If something is missing, please
contact your dealer as soon as possible.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
• To prevent fire or shock hazard, do not expose this device to rain or moisture.
1. Transmitter × 1
does not use near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet
basement, or near a swimming pool.
• To avoid electrical shock, do not open this device.
• This
device should be operated to use only the power supply included with it
or provided as an accessory.
• Do not overload wall outlets and extension cords as this can result in the risk
of fire or electrical shock.
• Do not attempt to service this device yourself. Refer servicing to qualified
personnel only.
Caution: Changes or modifications not expressly approved by the
Party responsible for compliance could void the user’s authority to
operate the equipment.
■ Note:
This equipment has been tested and found to comply with the limits for a
class B digital device, pursuant to Part 15 of the FCC Rules, or BZT and
CE EMC directive. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy, if not
installed and used in accordance with the instruction, it may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
.
1
SSG2 2 5 0 T
2. Receiver × 1
SSG2 2 5 0 R
3. Power adapter ! × 2
□ (120VAC to 9VDC)
DC in Jack ( 9V 400mA)
4. Audio Cable × 2
□ RCA to 3.5mm stereo connector
5. □ IR extender × 1
6. Owner’s manual
× 1
2