User's Manual

B. Introduction to 2.4GHz Wireless Audio Link
This sender system is a wireless audio sender that uses advanced wireless
communication technology to deliver consistently sharp audio up to 100 meters
away. By transmitting at a very high frequency (2.4 GHz), it avoids the
crowded 900 MHz band used by many cordless telephones and other wireless
audio transmitters. It
’s superior quality is due to wide-band FM rather than AM
signal modulation. Circular polarized high-gain directional transmitting and
receiving antennas are used to minimize interference from unwanted signals
and maximize the signal range.
It also integrates an UHF remote control extender to allow you to control the
video/audio source from another room using your existing remote controller.
Using sender system, you can enjoy greater convenience in many ways.
3
■
The Using Attention
1. The outlet of the power supply must have the same voltage as the local area.
2. Be sure the transmitter and the receiver were connected to the equipment
correctly
3. When switch is off from transmitter or receiver, it needs to wait for a few
seconds in order to restart again.
4. Adjust antenna plate for least interference. (Adjustment cannot rotate more
than ± 180° )
5. In most situations, one set of equipment has a better feature within 100
meter. When two equipment or more is used at the same time, used
different channels. But a transmitter can be used with several receivers at
the same time.
6. The channel selectors allow you to choose the channel for best feature and
least interference.
7. When the equipment is operating, please do not use a microwave oven near
by.
8. The remote control should face to the receiver IR remote control window,
and the transmitter IR remote control window (or IR extender) should face
to the source Audio equipment. The IR remote has to be within the standard
distance.
4