User Manual

Wireless Headphones
10
Headphones are dual channel (A and B channel) infrared wireless.
Channel must be selected to match the display monitor being viewed (see
below)
Headphones must be in line of sight of display monitor to receive audio signal
Headphones require (2) AAA batteries.
NOTE: Please make sure volume control is set to low for the safety of the next
user (excessive volume can cause permanent damage)
Please note: headphones will power off automatically if no audio is played for
more than 3 minutes. This is so the batteries aren’t drained. In the event this
happens, just turn the switch off then on.
Volume control
Power on/off switch
Channel A/B selection switch
Battery cover (depress and slide down to remove)
Monitor “A/B”
identification location
Follow menu sequence below:
Audio>IR transmitter (Monitor “A”
or “B” will be shown)
NOTE: BE CAREFUL, AS MONITOR
CAN BE CHANGED IN THIS MENU
IF MONITOR IS SELECTED