Owners manual

Mass Air Flow Installation Instructions
Part #69149
1. Locate the factory Mass Air Flow sensor located in the air intake tube
of the vehicle.
2. Remove the two screws that mount the factory Mass Air Flow Sensor to
the air intake tube.
3. Install the JET Powr-Flo Mass Air Sensor in the intake tube using the
factory screws that you previously removed.
4. Start vehicle and verify that the check engine light is not on.
5. Put your factory sensor away in a safe place for a spare.
JET Performance Products
17491 Apex Circle
Huntington Beach, CA 92647
Tech:714-848-5515 Fax: [phone]
[e-mail]
www.jetchip.com