Manual

Installation Check List
Chemical hook-up
This unit is equipped with three (3) chemical pumps; located behind the bottom panel (below
the door). Each will inject a different chemical product at a specific time during the wash and
rinse cycle. The chemical pumps have sufficient length of tubing hose which can be inserted
into gallon size containers, near the dishwasher. The lines can be passed through the center of
the dishwasher out either side.
The chemical pumps have colored tubing for ease of identification.
The colors are as follow:
Red for Detergent
Clear for Sanitizer
Blue for Rinse-additive
To prime the pumps; push the toggle switch above
each pump until the products have reached the
sump.
Suggested chemical use and quantities.
Detergent:
Sanitizer:
Rinse-Aid:
See local health code for appropriate quantities and usage.
Contact your chemical representatives for calibration and supply.
WARNING
Whenever manipulating chemicals, use appropriate protection (eyes and
hands) as these chemicals are corrosive.
- Is the dishwasher connected electrically?
- Is the breaker (in the electrical panel) switched on?
- Is there water connected to the dishwasher?
- Is the water valve opened?
- Are the chemicals properly set?
9
PRIMING SWITCHES
WASH COUNTER
CHEMICAL PUMPS
Extra heavy-duty non-foaming commercial liquid dish detergent
required. Adjust to .30% concentration.
Liquid chlorine bleach (sodium hypochlorite - 5.25%
solution) adjusted to 50 PPM.
Low foam rinse-aid, surfactant isopropanol, adjusted for
proper sheeting.