OPERATOR'S MANUAL Bandsaws HBS-916W & 1018W

it WARNING
.
Read and understand the entire
instruction manual before attempting
assembly or operation.
All JET bandsaws are designed and
intended for use by properly trained and
experienced personnel only. If you are
not familiar with the proper and safe
operation of a bandsaw, do not use until
proper training and knowledge have
been obtained.
.
.
Always wear approved safety glasses/face
shields while using this machine.
.
Make certain the machine is properly
grounded.
.
Before operating the machine, remove tie,
rings, watches, other jewelry, and roll up
sleeves above the elbows. Remove all
loose clothing and confine long hair. Do
NOT wear gloves.
.
Keep the floor around the machineclean
and free of scrap material, oil and grease.
.
Keep machine guards in place at all times
when the machine is in use. If removedfor
maintenance purposes, use extreme caution
and replace the guards immediately.
.
Do NOT over reach. Maintain a balanced
stance at all times so that you do not fall or
lean against blades or other moving parts.
.
Make all machine adjustments or
maintenance with the machine unplugged
from the power source.
.
Use the right tool. Don't force a tool or
attachment to do a job which it was not
designed for.
.
Replace warning labels if they become
obscured or removed.
.
Make certain the motor switch is in the OFF
position before connecting the machine to
the power supply.
.
Give your work undivided attention. Looking
around, carrying on a conversation, and
"horse-play" are careless acts that can
result in serious injury.
.
Keep visitors a safe distance from the work
area.
.
Use recommended accessories; improper
accessories may be hazardous.
.
Make a habit of checking to see that keys
and adjusting wrenches are removed before
turning on the machine.
.
Always keep hands and fingers away from
the blade when the machine is running.
.
Never hand hold the material. Always use
the vise and clamp it securely.
.
Keep belt guard, blade guards, and wheel
covers in place and in working order.
.
Always provide adequate support for long
and heavy material.
.
Use a sharp blade and keep machine clean
for best and safest performance.
.
Failure to comply with all of these warnings
may cause serious injury.