Manualshelf

Instructions / Assembly

ManualsBrandsJet ManualsAutomotive3-Ton 2-Speed Electric Hoist 3-Phase 10 ft. Lift, with Electric 2-Speed Trolley 3PH, and 4 Button Wired Pendant
12345678910
7
7.2 460 Volt models
Refer to Figure 7-1.
TS050-460
TS100-460
TS300-460
TS500-460
Capacity
1/2 ton (500 kg)
1 ton (1000 kg)
3 ton (3000 kg)
5 ton (5000 kg)
Lift
All models available in standard 10, 15 or 20 ft. lifts.
Custom lengths available up to 100 ft. for most models
1
Load Chain
(diameter x pitch)
in.
Ø .248 x .752
Ø .280 x .795
Ø .394 x 1.189
Ø .441 x 1.339
mm
Ø 6.3 x 19.1
Ø 7.1 x 20.2
Ø 10 x 30.2
Ø 11.2 x 34
Number of falls
1
1
2
2
Lifting speeds
(ft/min)
High spd
33
26
21
13
Low spd
8
7
5
3
Pendant controls
Dependent upon lift and trolley use; see sect. 18.0.
Duty
Cycle
Time Rating
30 min.
Duty Rating %
H4 (40/20)
Max. starts
per hour
240
Motor
Horsepower
High
1.5
2
5
5
Low
0.4
0.5
1.2
1.2
Pole
2/8
Cycle
60 Hz
Phase
3
Voltage
460 V
Current Draw
(amperage)
High spd.
3.5
5.5
8.4
8.4
Low spd.
2
2.8
4.2
4.2
Noise level
2
75 db
Gearbox capacity
1.2 L
1.4L
4L
4L
Dimensions (Figure 7-1)
A
22-7/16" (570mm)
24-7/16" (620mm)
28-1/8" (715mm)
28-1/8" (715mm)
B
10-5/8" (270mm)
11-13/16" (300mm)
13-3/8" (340mm)
13-3/8" (340mm)
C
12-3/16" (310mm)
12-5/8" (320mm)
14-3/4" (375mm)
14-3/4" (375mm)
D
6-1/2" (165mm)
7-1/16" (180mm)
8-11/16" (220mm)
8-11/16" (220mm)
E
14-3/4" (375mm)
16-1/8" (410mm)
20-7/8" (530mm)
20-7/8" (530mm)
F
7-1/2" (190mm)
7-11/16" (195mm)
10-5/8" (270mm)
10-5/8" (270mm)
G
7-5/16" (185mm)
8-11/16" (220mm)
10-1/4" (260mm)
10-1/4" (260mm)
H1
19-11/16" (500mm)
21-5/8" (550mm)
-----
-----
H2
-----
-----
41-5/16" (1050mm)
43-5/16" (1100mm)
Table 2
1
Stock numbers vary based upon chain length. Determine needs, then see JET website for stock numbers.
2
Measured at 1m horizontally from hoist during normal operation. The specified values are emission levels and are not
necessarily to be seen as safe operating levels. As workplace conditions vary, this information is intended to allow the
user to make a better estimation of the hazards and risks involved only.
The specifications in this manual were current at time of publication, but because of our policy of continuous
improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring
obligations.