Instructions / Assembly

ManualsBrandsJet ManualsAutomotive3-Ton 2-Speed Electric Hoist 3-Phase 10 ft. Lift, with Electric 2-Speed Trolley 3PH, and 4 Button Wired Pendant

Read and understand the

entire contents of this manual before installing

hoist or attempting operation. Failure to comply

may cause serious injury.

8.0 Unpacking

Remove hoist from its crate and carefully inspect its

components for shipping damage. Report any

damage immediately to your distributor and

shipping agent. Do not discard any shipping

material until hoist is installed and running properly.

Contents of shipping crate

1 Electric chain hoist

1 Chain container with fasteners

1 Power supply cord

1 Pendant control

1 Chain gauge (attached to pendant cord)

1 Top hook assembly

1 Bottom hook assembly with chain

1 Operating instructions & parts manual

1 Product registration card

1 Test certificate

9.0 Installation

Support for the hoist may be hook, clevis pin, trolley,

or beam clamp. Whatever method of suspension is

chosen, the support components must be rated

equal to, or greater than the capacity of the chain

hoist. Supporting structures (such as I-Beams)

should be installed by properly licensed professional

installers.

If you are using the hoist with a trolley, refer to the

trolley manual for instructions on securing the

control cord and maintaining proper slack in the cord

during operation. Optional pendant cords for use

with a trolley system are shown in section 18.0

TIP: If suspending from a trolley, it may be easier to

remove top hook from hoist and attach it to trolley

load plate, then re-attach hoist to the hook.

Make sure the suspension system used is properly

grounded, in addition to the grounding of the hoist.

9.1 Mounting top hook

If the TS-series hoist will be used without a trolley,

attach the top hook with the provided pin(s), lock

washer(s), hex nut(s) and cotter pin(s).

If the TS-series hoist will be used with a JET MT

trolley, do not attach the top hook. Instead mount

the hoist to the trolley bottom using the provided

fasteners through the aligned holes. See Trolley

manual.

9.2 Power cable

All electrical connections must

be made by qualified personnel. Read sect. 10.0

before connecting this unit to power.

Hoist only: Connect the power cable leads to an

extension and run the line to the electrical panel, or

install a UL/CSA approved plug to draw from a

receptacle.

Hoist with MT trolley: The trolley will draw its power

through the hoist. Connect trolley cable to hoist.

Then direct hoist cable to the power source. See

trolley manual for instructions.

IMPORTANT: The power cable should be directed

so that it is safely out of the way of loads. If a trolley

is used, power cable must not interfere with, or be

pinched by, trolley travel. See Figure 9-1 for a