User Manual
Table Of Contents
- Belt Drive Bench Lathe, 13x40-inch
- Warranty and Service
- Table of Contents
- Warnings
- Specifications
- Dimensions of optional stand (p/n 321443AK)
- Assembly
- Lubrication
- Electrical Connections
- General Description
- Controls
- Adjustments
- Break-In Procedure
- Speed Selection
- Feed and Thread Selection
- Change Gear Replacement
- Thread Cutting
- Thread and Feed Chart
- Automatic Feed Operation and Feed Changes
- Powered Carriage Travel
- Saddle Adjustment
- Cross Slide Adjustment
- Compound Rest Adjustment
- Tailstock Adjustment
- Half Nut Gib Adjustment
- Headstock Alignment
- Removing Gap Bridge
- Installing Gap Bridge
12
Index No Part No Description Size Qty
157 ............ GHB1340A-02502 ..... Rubber Mat (GHB-1340A only)................................ ...................................... 1
.................. GHB1440A-02503 ..... Rubber Mat (GHB-1440A only)................................ ...................................... 1
158 ............ GHB1440A-02102 ..... Headstock Side Board (GHB-1440A only)............... ...................................... 1
159 ............ GB117 ....................... Pin............................................................................ 5 x 20 ............................ 2
160 ............ TS-1503041 .............. Hex Socket Cap Screw ............................................ M6 x 16 ......................... 4
.................. GHB1340A-160 ......... Oil Sight Glass (not shown) (GHB-1340A serial #10052363A and lower).......... 1
.................. GHB1340A-160M ...... Oil Sight Glass (not shown) ..................................... M27x1.5 ......................... 1
(GHB-1340A serial #10102364A and higher)