User Manual
Table Of Contents
- Belt Drive Bench Lathe, 13x40-inch
- Warranty and Service
- Table of Contents
- Warnings
- Specifications
- Dimensions of optional stand (p/n 321443AK)
- Assembly
- Lubrication
- Electrical Connections
- General Description
- Controls
- Adjustments
- Break-In Procedure
- Speed Selection
- Feed and Thread Selection
- Change Gear Replacement
- Thread Cutting
- Thread and Feed Chart
- Automatic Feed Operation and Feed Changes
- Powered Carriage Travel
- Saddle Adjustment
- Cross Slide Adjustment
- Compound Rest Adjustment
- Tailstock Adjustment
- Half Nut Gib Adjustment
- Headstock Alignment
- Removing Gap Bridge
- Installing Gap Bridge
6
Dimensions of optional stand (p/n 321443AK)
To purchase this optional stand for the BDB-1340A Lathe, contact your dealer or call JET customer
service.
Assembly
Contents of the Shipping Container
(Figures 1 and 2)
1 Lathe
1 Steady Rest (mounted on lathe)
1 Follow Rest (mounted on lathe)
1 6" Three Jaw Chuck (mounted on lathe)
1 8" Four Jaw Chuck
1 12" Face Plate (strapped to container)
3 Cam Locks
3 Socket Head Cap Screws
1 Tool Box (strapped to container)
1 Chip Tray
1 Lifting Hook
2 Lifting Blocks
Tool Box:
3 Open End Wrenches (9/11, 10/12,
12/14mm)
1 Touch-Up Paint
1 Oil Can
1 Hex Socket Wrench Set (2.5, 3, 4, 5, 6,
8mm)
2 Shear Pins
1 33T Gear
1 44T Gear
1 46T Gear
1 48T Gear
1 52T Gear
2 T-Handle Chuck Wrenches
1 Tool Post Wrench
2 MT-3 Centers
1 MT-3 to MT-5 Sleeve
1 Cross Point Screwdriver
1 Flat Head Screwdriver
1 Key for Cam Locks
1 Operating Instructions
1 Parts List
1 Warranty Card
Figure 1
(stand not included)
Figure 2