User Manual
Table Of Contents
- Belt Drive Bench Lathe, 13x40-inch
- Warranty and Service
- Table of Contents
- Warnings
- Specifications
- Dimensions of optional stand (p/n 321443AK)
- Assembly
- Lubrication
- Electrical Connections
- General Description
- Controls
- Adjustments
- Break-In Procedure
- Speed Selection
- Feed and Thread Selection
- Change Gear Replacement
- Thread Cutting
- Thread and Feed Chart
- Automatic Feed Operation and Feed Changes
- Powered Carriage Travel
- Saddle Adjustment
- Cross Slide Adjustment
- Compound Rest Adjustment
- Tailstock Adjustment
- Half Nut Gib Adjustment
- Headstock Alignment
- Removing Gap Bridge
- Installing Gap Bridge
47
26.1 Electrical Schematic – BDB-1340A
26.2 Electrical Schematic Parts List – BDB-1340A
Index No Part No Description Size Qty.
1 ............... GHB1340-KA1 .......... Relay........................................................................ CA2-DN140................... 1
2 ............... GHB1340-KM1 .......... A.C. Contactor ......................................................... LC1-D259...................... 1
3 ............... GHB1340-KM2 .......... A.C. Contactor ......................................................... LC1-D259...................... 1
4 ............... GHB1340-TC ............ Control Transformer................................................. JBK3-63 ........................ 1
5 ............... GHB1340A-SQ2........ Stroke Switch ........................................................... LXW5-11D1 .................. 1
6 ................ GHB1340A-SQ3........ Stroke Switch ........................................................... LXW5-11D1 .................. 1
7 ................ GHB1340-XT1........... Wiring Board ............................................................ JHY1-32 ........................ 1
8 ................ GHB1340-XT2........... Wiring Board ............................................................ JHY1-16 ........................ 1
9 ................ GHB1340-XB ............ Copper Plate (for grounding) ................................... ...................................... 1