Use and Care Manual

6
4.0 Specifications
Table 1
Model number
JMD-40GH JMD-40GHPF JMD-45GH JMD-45GHPF
Stock number 351040 351041 351045 351046
Motor and Electricals
Motor type Totally-enclosed, fan-cooled, induction
Horsepower 1.5
Phase single
Voltage 115/230 (prewired 115V)
Cycle 60 Hz
Listed FLA (full load amps) 20 / 10
Starting amps
68A/34A
Running amps (no load)
16.8A /8.4A
Start capacitor 400MFD 125VAC
Motor speed 1720 RPM
Motor cord AWM 600V 15AWG
Power cord SJT 3x3.31mm
2
12AWG 300V, 6 ft.
Power plug installed 20A (5-20P)
LED work lamp 12V, 6W; separate 115V power cord SJT 3x18AWG, 6 ft.
Recommended circuit size
1
20A / 15A
Sound emission without load
2
70dB
Capacities
Spindle taper R8
Spindle rotation Forward/Reverse
Drilling capacity
Mild steel 1-1/4 in. (32mm)
Cast iron 1-1/2 in. (38mm)
Face mill capacity Ø 4 in. (100mm)
End mill capacity Ø 3/4 in. (20mm)
Swing 20-1/2 in. (520mm) 19-11/16 in. (500mm)
Max. distance spindle to table 15-3/4 in. (400mm) 18-1/8 in. (460mm)
Spindle travel (manual) 5 in. (130mm)
Spindle travel (power feed) n/a 4-1/4 in. (107mm) n/a 4-1/4 in. (107mm)
Number of spindle speeds 6
Range of spindle speeds 65, 130, 220, 480, 925, 1550 RPM
Number of power feeds n/a 3 n/a 3
Range of power feeds n/a
0.005, 0.007,
0.010 in.
(0.12/0.18/0.2mm)
n/a
0.005, 0.007,
0.010 in.
(0.12/0.18/0.2mm)
Head pivot around column 360 deg.
Head swivel 90 deg. left, 30 deg. right
Max. table travel (longitudinal) 20-1/2 in. (520mm)
Max. cross travel 8-1/4 in. (210mm)
Main materials
Column Cast iron
Table Cast iron
Head Cast iron
Dimensions
Quill diameter 3 in. (75mm)
Column diameter 4-1/2 in. (115mm) n/a (square design)
Table working surface (LxW) 32-1/4 x 9-1/2 in. (820 x 240mm)
Number of T-slots 4
T-slot size (WxD) 5/8 x 1 in. (16 x 26mm)
Base dimensions 24-1/4 x 15-15/16 in. (615 x 405mm) 26-11/16 x 15-15/16 in. (653 x 405mm)