Use and Care Manual

7
Assembly
Read and understand all
assembly instructions before attempting
assembly! Failure to comply may cause
serious injury!
Do not attempt to turn on
power before this machine is completely
assembled.
Before Assembly
1. Remove contents from shipping container.
2. Compare contents of shipping container with
the list on page 6. Report any shortages or
damage to your JET distributor.
3. Clean all rust protected surfaces with
kerosene or a light solvent. Do not use
lacquer thinner, paint thinner, or gasoline.
These will damage plastic components and
painted surfaces.
Column to Base
Referring to Figure 1:
1. Place the base (A) on a level floor.
2. Place the column assembly (B) on the base
(A) and align the holes in the column support
with the holes in the base.
3. Using a 19mm wrench, secure the column (B)
with four M10 x 40 hex cap screws (C) to the
base.
Table Bracket and Rack
Referring to Figures 2 and 3:
When shipped, the rack ring and rack are bundled
together with the column in plastic wrap.
1. Remove the wrap and take the rack ring (D)
and rack (E) off the column (B).
2. Insert worm gear shaft (G) through hole of
bracket (F) and mesh with worm (H).
3. Position rack (E) in U-slot of bracket with
arrow pointing upward, and slide this
assembly together onto the column.
4. Slide rack ring (D) over column (B), placing it
so it rests against rack (E) as shown in Figure
3. Tighten firmly with 3mm hex wrench
(provided).
Figure 1
Figure 2
Figure 3