Use and Care Manual

12
Figure 7-4: belt de-tensioning
Figure 7-5: belt positioning
7.6 Vise adjustment
Refer to Figure 7-6.
The workpiece is placed between the vise jaws with
required amount to be cut-off extending past the
blade.
To position floating jaw, lift rack block (R) and slide
jaw into general position. Lower rack block and turn
handwheel (S) to tighten jaw against workpiece.
The floating jaw can be positioned before or behind
blade to clear angle of bow when mitering. Loosen
both handles (T) and push assembly along T-slot.
Make sure floating jaw will clear blade and bow
components, then tighten both handles (T).
Figure 7-6: vise adjustment
7.7 Bow swivel adjustment
Refer to Figures 7-7 and 7-8.
1. Remove 90° stop pin (V).
2. Lift up on lever (W) and push bow to desired
angle according to scale (X).
3. Push down lever (W) all the way until it locks
into position. If lever will not push all the way
down or does not have sufficient tightness to
secure bow, adjust screw beneath lever (W
1
).
Figure 7-7: bow swivel adjustment
Figure 7-8: bow locking lever
7.8 Material stop
Refer to Figure 7-9.
The material stop is generally used when cutting
multiple pieces to the same length. Position stop
block (Y) desired distance away from blade and
tighten knob.
If closer reach is needed toward blade, insert small
rod and upper knob (Z).
Figure 7-9: material stop